Z5 binder 


 Category and purpose: 
 ※ ordinary type (commonly known as: ceramic tile adhesives): Suitable for indoor, exterior walls, ground paste of ceramic tiles can be used for the waterproofing membrane Plastering 
 Layer of protection. 
 The ※ enhanced (commonly known as: the wave of brick binder): applies to indoor and external walls of the ground paste of brick, whole body tiles. 
 ※ strong type (commonly known as: strong rubber powder): Suitable for indoor and external walls of the ground paste thin marble, large stone, granite 
 Rock, polyethylene plate, extruded board, rock wool board. 
 For the environment: 
 ☆ indoor and the ☆ outdoor ☆ wall ☆ ☆ cold regions of the ground ☆ pool the ☆ bathroom ☆ Kitchen 
 Primary treatment: 
 Sure the flat solid substrate, without hollowing, the substrate surface is clean, no oil, from film, dust and loose material, dirt 
 Stains. For absorbent largest grass-roots wetting with water. 
 Technical parameters: a report co-JC/T547-2005 

 Test 
 Test 
 Results 
 If test items to test the conclusions of the results of technical indicators 
 Original tensile adhesive strength, Mpa 0.7 ≥ 0.5 qualified 
 Tensile adhesive strength after immersion in water, Mpa 0.7 ≥ 0.5 qualified 
 Tensile adhesion strength after thermal aging, Mpa 0.6 ≥ 0.5 qualified 
 Tensile adhesion strength after freeze-thaw cycle, Mpa 0.6 ≥ 0.5 qualified 
 Airing time, 20min tensile adhesive strength, Mpa 0.5 ≥ 0.5 qualified 


 Comparative table: 
 Z5 trowel wiping process with the traditional cement mortar work paste tile construction contrast 
 Contrast to project-type Z5 binder Man wiping process traditional cement mortar and glue process 
 The world recognized degree that new technologies should be promoted product is not recommended (the Beijing Construction Committee 1997.298) 
 2 choice of materials, polymers, high-quality cement, quartz sand. Polyvinyl formal construction adhesive (such as the 108,107 plastic, etc.), cement, sand (moisture content, clay) 
 3 hollowing phenomenon eliminate the existence of rework 
 Off phenomenon does not occur often, causing injury to eyesores 
 5 market price of about 2.0 yuan / kg (Universal) of about 0.8 yuan / kg 
 6 per m2 amount of 3-5kg 11-25kg 
 Combined with the thickness of 2-5mm 10-20mm 
 8 per m2 cost 6-10 $ $ 8.8-20 
 9 Cost comparison of 100% to 150% -200% 
 10 implementation of standards the JC/547-94 standard 
 Meet on DBJ-01-37-1998 standard does not meet the 
 The 11 environmental performance of the HJBZ28-1999 "for environmental labeling products technical requirements" does not meet the standard 
 12 shipments with a total weight / m 2 3-5kg 11-25kg, 4-5 times 
 13 the total weight of the building / m 2 3-5kg 11-25kg, 4-5 times 
 14 to increase interior space to increase to reduce 


 Z5 trowel to wipe craft glue Pa or 903 adhesive tiling construction compared 

 Construction Technology: 
 1, the binder powder removed from the plastic barrel in the barrel into clean cold water to the barrel body assembly line marked. (Every 20 
 Kg bags binder and water is about 5.5 liters) 
 2, the binder powder into the bucket with an electric mixer, stir to evenly without caking. 
 3, using a special scraper mortar full batch of the base surface 3-5mm thick, then use the scraper tooth side to pull out the stripes straight or S-shaped 
 Like (the scraper flat and grass-roots plane intersecting 45 degrees to 60 degrees, it is recommended based on tile size selection of different tooth depth of the scraper). 
 4, the tiles do not need soaking, simply press the order pasted on the wall or ground compaction can. 
 Can adjust the tile location within a specified time to achieve optimal results, the excess glue in the glue to dry before removal. 
 Note: 
 ★ brick panels do not need to immerse themselves in water, highly absorbent tiles or grass-roots soaking a few minutes or the spray wetting. 
 ★ low early strength, 7d can reach the intensity of use. Within 24 hours to avoid heavy-duty tile surface. 
 ★ winter antifreeze available, construction can be less than -10 ℃. 
 Storage and transport: 
 , Pack size of 20kg / bag. 
 2 attention to moisture, moisture, exposure, storage and transportation and storage of up to nine months. 
 3, This product is nontoxic, odorless, non-polluting, non-flammable, non-explosive, according to general cargo transport. 
 Projects: 
 Changchun City Experimental Primary School, Harbin University of Technology, Northeast Agricultural University, Beijing University Biological City, People's University swimming pool, 
 Central International Trade Center, Tianyuan Hong Kong, the Shijingshan Government Accounting Office, Bishuizhuangyuan, Beijing Armed Police General Hospital, Oriental Kenzo, the Navy swimming pool, 
 Zhongnanhai, Phoenix, Tsinghua Science Park, North China Electric Power University, the first city in the country the United States, the National Aquatics Center, Mudanjiang municipal government, 
 Qiaobo Ski Museum.